Grafikpress JSVE-50 eldriven *beställningsvara*

TECHNICAL DATA JSVE-50

Plate format (bed size) 50x100cm

Thickness of bed 1cm

Measurements of the press:

Length (of the side frames) 59cm

Width (overall) 86cm

Height (incl. stand) 114cm

Work height 86cm

Length of rollers 50cm

Diameter of upper roller 12.5cm

Thickness of wall of upper roller 1,7cm

Diameter of lower solid roller 8cm

Max. opening between bed and upper roller 4cm

Thickness os steel side frames 2cm

Screw thread spindles (metric) M16

Weight 100 kg

Electric Voltage AC (110 Volt optional) 220 V

Power electric motor 750 Watt Speed of motor 1400 RPM

Total gearing ratio 1 : 256

Printing speed 2,3 cm/sec

Pallet size, wrapped in cardboard and plastic foil, without stand, as advised for road transport .WxLxH 90x120x60cm

Weight of pallet as described above (without stand) 160 kg

Pallet size, wrapped in cardboard and plastic foil, with stand, as advised for road transport. WxLxH (with stand) 80x120x150cm Weight of pallet as described above (with stand) 200 kg.

The JSVE series has a drive system with an electric motor, driven on the lower roller. The gear-wheels are protected with a steel cover. The hard synthetic plate runs between adjustable guide strips, mounted on the solid steel frames. The pressure springs are found under the upper roller. If the spindles are loosened the upper roller is raised by spring pressure. This results in a space appearing between the upper roller and the bed, thus facilitating the sliding of the printing sandwich. This feature makes this press also very suitable for lino and woodcut printing. Shims of leather or card board can be placed under the spindles thus providing more flexibility during printing (useful when printing woodcuts, to compensate a little bit the irregularities in the wood). The basic design of these electric presses is taken from the JSV-series, with the following changes and features; driven by electric motor, 230 V, 0,75 kW, single speed. An electric motor for 110 V can be supplied. control panel features, left, right and a highlighted stop button. safety guard on both sides of the upper roller, keeps fingers away from roller. This safety guard is made of a small plastic roller, over the width of the bed. This roller rests on the bed and will lift when necessary for the passage of the plate and paper. motor automatically shuts off at both ends of bed (micro-switches)."